The Welder-Cleaner transfer system, designed for floor space savings, consists of a 3 axis overhead gantry mechanism that takes welded sashes (or frames) from the welder and transfer them to the cleaner magazine which then feeds one sash (or frame) at a time to the cleaner. The design of the transfer system allows for a truly automated and continuous welding and cleaning operation. With the optional welder pre-loader, the Welder-Cleaner transfer system does not allow for any idle machine time.

Features:

• Welds and Cleans - Min. 12” x 12” sash, Max. 60” x 60” sash
• Cycle Time: 30 seconds per window
• Welding Tolerance: +/- .015
• Cleaning Tolerance: +/- .015
• Footprint: 22’x 14’
• 4-axis gantry for sash transfer
• Equipped with 4 pocket anodized aluminum grippers
• Blue powder coated welded base
• White powder coated guards
• Ergonomic working height, fine adjustments made via leveling feet
• Infeed - Automatic Welder Loader, equipped with pre-load tracks to accommodate any sash size between and including min and max
• Controls - Trio
• Filter/Regulator with OSHA compliant lockout/tagout
• Equipped with safety relief set to 150psi
• Coalescing air filter
• ½” air hookup (1 drop)
• Minimum operating requirement of 80psi
• Maximum operating requirement of 125psi
• Minimum required air flow 25 cfm’s
• Lubrication - Grease fitting at each ball-screw
• Saws/Tooling: Bottom skive knife, Top skive knife, 4” saw blade, ¼” pilot router
• Electrical: 240V AC (20A 3-Phase) or 480V AC(15A – 3 Phase) hookup
• Fusible disconnect with OSHA compliant lockout/tagout
• Fixture
  • Vertical clamping on welder and cleaner
  • Horizontal clamping on welder and cleaner
• Outfeed conveyor